Optional Transmitter Setup; Trouble Shooting Guide For Safe Technology - Horizon Hobby Apprentice S 2 1.2m Manuel D'utilisation

Optional Transmitter Setup

If using any DSMX transmitter other than the included DXS (3 pos gear switch)
the radio will have to be configured correctly for the SAFE system to work
properly.
• SAFE Flight mode is selected using Channel 5 signal (high, middle, low)
• Panic mode is selected with Channel 6 signal (high, low)
Refer to your transmitter's manual for more information about transmitter
setup.
If using a 2 pos switch for Safe flight modes only Beginner and Experienced
modes will be active.

Trouble Shooting Guide for SAFE Technology

Problem Possible Cause
Flying over recommended airspeed Reduce air speed
Damaged propeller or spinner
Imbalanced propeller
Motor vibration
Oscillation
Loose receiver
Loose aircraft controls
Worn parts
Irregular servo rotation
Trim is at extreme and
aircraft does not fly Trim is not at neutral
straight or level
®
Start all transmitter programming with a blank ACRO model
Set Dual Rates to
Set Servo Travel to
DX6i
DX7S
DX8
DX6e
DX6 (Gen2)
DX7 (Gen2)
DX8 (Gen2)
DX9
DX10t
DX18
DX20
iX12
iX20
NX6
NX8
NX10
Replace propeller or spinner
Balance the propeller. For more information, view John Redman's propeller balancing video
at www.horizonhobby.com
Replace parts or correctly align all parts and tighten fasteners as needed
Total system failure. Align and secure receiver in fuselage
Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)
Adjust gain to compensate for parts wear or replace worn parts (especially propeller, pivot points or servo)
Replace servo
If you adjust trim more than 4 clicks, adjust the clevis to mechanically remove trim
20
Computerized Transmitter Setup
(perform a model reset), then name the model.
HIGH 100%
LOW 70%
100%
1. Go to the SETUP LIST MENU
2. Set MODEL TYPE: ACRO
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set WING TYPE: NORMAL, TAIL: NORMAL
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set AIRCRAFT WING: NORMAL, TAIL: NORMAL
Solution