Contact Information; Fcc Information; Ic Information - Horizon Hobby Apprentice S 2 1.2m Manuel D'utilisation

Warranty Requirements
For Warranty consideration, you must include your original sales receipt
verifying the proof-of-purchase date. Provided warranty conditions have
been met, your Product will be serviced or replaced free of charge. Service or
replacement decisions are at the sole discretion of Horizon.
Non-Warranty Service
Should your service not be covered by warranty, service will be
completed and payment will be required without notification or estimate
of the expense unless the expense exceeds 50% of the retail purchase
cost. By submitting the item for service you are agreeing to payment of the
service without notification. Service estimates are available upon request. You
must include this request with your item submitted for service. Non-warranty
service estimates will be billed a minimum of ½ hour of labor. In addition you will
be billed for return freight. Horizon accepts money orders and cashier's checks,

Contact Information

Country of Purchase
Horizon Service Center (Repairs and Repair Requests)
United States of
Horizon Product Support (Product Technical Assistance)
America
Sales
Horizon Technischer Service
European Union
Sales: Horizon Hobby GmbH

FCC Information

Contains FCC ID: BRWKATY1T
BRWSPMSR6200A
This equipment complies with FCC and IC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator and/or antenna and your
body (excluding fingers, hands, wrists, ankles and feet). This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
Supplier's Declaration of Conformity
HBZ Apprentice S 2 RTF and BNF (HBZ31000, HBZ31500)
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.

IC Information

Contains IC: 6157A-KATY1T
6157A-SPMSR6200A
CAN ICES-3 (B)/NMB-3(B)
This device contains license-exempt transmitter(s)/receivers(s) that comply
with Innovation, Science, and Economic Development Canada's license-exempt
RSS(s). Operation is subject to the following 2 conditions:
Horizon Hobby
23
as well as Visa, MasterCard, American Express, and Discover cards. By submitting
any item to Horizon for service, you are agreeing to Horizon's Terms and
Conditions found on our website http://www.horizonhobby.com/content/service-
center_render-service-center.
ATTENTION: Horizon service is limited to Product compliant in the
country of use and ownership. If received, a non-compliant Product will
not be serviced. Further, the sender will be responsible for arranging
return shipment of the un-serviced Product, through a carrier of the
sender's choice and at the sender's expense. Horizon will hold non-
compliant Product for a period of 60 days from notification, after which it
will be discarded.
Contact Information
servicecenter.horizonhobby.com/
RequestForm/
productsupport@horizonhobby.com
877-504-0233
websales@horizonhobby.com
800-338-4639
service@horizonhobby.eu
+49 (0) 4121 2655 100
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Horizon Hobby, LLC
2904 Research Rd.,
Champaign, IL 61822
Email: compliance@horizonhobby.com
Web: HorizonHobby.com
1. This device may not cause interference.
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
EN
10/15
Address
2904 Research Rd
Champaign, Illinois, 61822
USA
Hanskampring 9
D 22885 Barsbüttel, Germany
Apprentice S 2 1.2m
®