Configuring The Bus Coupler With Windp - Aventics PROFIBUS DP Mode D'emploi

AVENTICS | PROFIBUS DP | R499050016–BDL–001–AE
7.2

Configuring the bus coupler with WinDP

The description in this section refers to the software WinDP,
version 1.94 (AVENTICS order no. 1070077945). WinDP also
contains online documentation which has to be observed during
operation.
The configuration steps laid out in this section are superior to
the settings on the bus coupler which have already been
described (see "Making presettings" on page 101) and are a part
of the entire system's bus master configuration.
The work being described here may only be carried out by
qualified electronics personnel and in compliance with the
operator's documentation on configuring the bus master as
well as applicable technical standards, directives, and
safety regulations.
Before starting configuration, the following steps must have
been carried out and completed on the bus coupler:
W
You have assembled the bus coupler and valve terminals
(see "Assembly" on page 89).
W
You have connected the bus coupler
(see "Connecting the bus coupler electrically" on page 91).
W
You have carried out the presettings (see "Making
presettings" on page 101).
Commissioning and Operation
111