Aventics PROFIBUS DP Mode D'emploi page 133

AVENTICS | PROFIBUS DP | R499050016–BDL–001–AE
3. Attach the (additional) input (5) or output module (4) to the tie
rods (6).
– Make sure the seals (3) have been correctly inserted and
that the contacts have been properly connected.
4. Retighten the E end plate (2) after the last input module (5)
or output module (4) (2 hexagonal socket-head screws
DIN 912–M4 (1), wrench size 3). Tightening torque: 2.5 to
3 Nm.
5. Establish the connections (see "Connecting bus coupler logic
and load supply" on page 95).
6. Adjust the configuration (see "Configuring the bus coupler
with WinDP" on page 111).
Disassembly and Exchange
133