Charging And Replacing The Battery - StarLab ErgoOne E Mode D'emploi

CHARGING AND REPLACING THE BATTERY

A fully charged battery allows approx. eight hours (equals more than 4000 pipetting cycles)
of continuous pipetting of liquids with a viscosity and density similar to water.
IMPORTANT!
Before charging the battery ensure that the AC adapter is compatible with the line voltage in the
laboratory. Do not charge the device in an explosive environment. The battery can only be charged
inside the ErgoOne E.
®
Charge the battery
Pipetting during charging?
You can continue to work with the ErgoOne
If the battery is fully discharged, it will take a few minutes until the
minimum charge capacity needed to operate the instrument safely is
available.
NOTE:
The last settings are stored in the memory of the instrument. If the battery is fully
discharged or the battery is changed, these settings are saved.
Replace the battery
Remove the battery from the instrument, when it is not to be used
for longer periods.
a) Insert the charging cable plug for the
AC adapter into the jack at the top of the
ErgoOne E; charging starts automatically
®
b) During the charging, the bars for the
battery capacity run continually from the
bottom to the top. The battery is fully
charged, when the bars in the display have
stopped moving.
E during charging.
®
a) Open the battery compartment cover.
Remove the battery and pull the plug
gently out of the socket.
b) Insert the plug of the new battery into the
socket and insert the battery.
c) Put the battery compartment cover in
place again and close it.
A
B
C
ErgoOne E · User Manual · 29