Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.2 Inserting tubes and plates
Caution! Microplates melt at extremely high temperatures.
Only heat microplates made of polystyrene to a maximum
i
70 °C.
1.
Place the tubes or plate on the thermoblock by pressing gently
down.
For optimum temperature control, transfer the micro test tubes to
the exchangeable thermoblocks using Iso-Racks. The Iso-Rack re-
duces the heat exchange of the thermoblock with the environment.
If necessary close the Iso-Rack lid.
3.
If using the microplate thermoblock: put on the lid.
5 MAINTENANCE
5.1 Cleaning
Danger! Electric shock as a result of penetration of liquid.
Switch off the Mixer HC and disconnect it from the power sup-
i
ply before starting cleaning or disinfecting the thermoblocks.
Do not allow any liquids to enter the inside of the housing.
i
Do not use spray disinfection.
i
Only reconnect the unit to the power supply once it is comple-
i
tely dry.
Clean the exchangeable thermoblocks immediately if sample fluid enters
the bore holes or the surface.
1.
Clean with a mild, soap-based solution, using a lint-free cloth.
2.
Wipe off the soap solution with distilled water.
3.
Dry all cleaned parts.
Thermoblocks for Mixer HC· User Manual · 7
Publicité
Table des Matières
