Installation Procedure; Drive Mounting - Franklin Electric SubDrive15 Manuel Du Propriétaire

Installation Procedure

Drive Mounting

The SubDrive/MonoDrive unit should be mounted on a surface or backplate no smaller than the outer controller
dimensions in order to maintain the NEMA 3R rating. The controller must be mounted at least 18" (45.7 cm) off
the ground.
The controller is mounted using the hanging tab on the top side of the enclosure, as well as two (2) additional
mounting holes on the back side of the controller. All three (3) screw hole locations should be used to ensure the
controller is securely mounted to the backplate or wall.
250,5
[9.86]
"A"
"B"
"C"
"D"
53,9 140
[2.12] [5.51]
SubDrive/MonoDrive Connect
"E"
MODEL
SubDrive15,
MonoDrive
SubDrive20,
SubDrive30,
MonoDriveXT
SubDrive50
133,9
[5.27]
11
[0.43]
53,2
[2.09]
2X 7,7
[0.31]
"A" "B" "C" "D"
464.2 355.2 454.7 427.4
[18.28] [13.98] [17.90] [16.83]
539.4 430.4 529.9 502.6
[21.24] [16.94] [20.86] [19.79]
539.4 430.4 529.9 416.2
[21.24] [16.94] [20.86] [16.39]
"E"
157.4
[6.19]
157.4
[6.19]
168.4
[6.63]
23