Monitoring; Logs - Franklin Electric SubDrive15 Manuel Du Propriétaire

Auxiliary Input
This parameter controls how the controller will react when the AUX INPUT
control terminal is used. This can be set as either Fault with High or Fault with Low.
Default: Fault with High
[Reference "AUX In" screenshot as a supporting figure]
Moisture Sensor
This parameter controls how the controller will react when the WET SENSOR control
terminal is used. This can be set as either Fault with High or Fault with Low. The Fault
with High condition supports the Franklin Electric Moisture Sensor device. The Fault
with Low condition can be used with other unpowered dry contact switched input
devices.
Default: Fault with High
[Reference "WFS Config" screenshot as a supporting figure]

Monitoring

T
his screen allows for real-time monitoring of the system including:
• System Status
• System Pressure (analog pressure transducer required)
• Built-In Duplex Alternator Status
• Motor Speed
• Input Voltage
• Output Voltage
• Output Current
• System Information (Drive Model, Hardware Version, Software Version)

Logs

This screen allows the Fault History and Configuration Change History logs to be
viewed and emailed. This screen also displays the total Drive On Time and Motor Run
Time along with the actual date and time when each log entry occurred.
SubDrive/MonoDrive Connect
AUX In
WFS Config
35