Declaration Of Conformity - Franklin Electric SubDrive15 Manuel Du Propriétaire

SubDrive/MonoDrive Connect
Model No.
5870205003C
5870205103C
5870205203C
5870205303C
5870205403C
5870205503C
MOTOR OVERLOAD PROTECTION NOTE:
The drive electronics provide motor overload protection by preventing motor current from exceeding
the maximum Service Factor Amps (SFA). Motor overtemperature sensing is not provided by the drive.
BRANCH CIRCUIT PROTECTION
Integral solid state short circuit protection does not provide branch circuit protection. Branch circuit
protection must be provided in accordance with the National Electrical Code and any additional local
codes, or the equivalent. Drive shall be protected by inverse-time fuse or Circuit breaker only, rated 300
V, maximum and per the full-load motor output current rating as noted in the Fuse/Circuit Breaker and
Wire Sizing section below.
INTERNAL LITHIUM BATTERY
CAUTION: Never place lithium batteries in mouth. If swallowed, contact your physician or local poison
control center. If battery is damaged, do not use. Battery shall be serviced or replaced by a qualified
serviceman.
Store new batteries only in the manufacturer's containers. Dispose/recycle used and damaged batteries
per local, regional, and national laws and regulations.
MAINTENANCE
Unless needed by accessory kit or noted within this manual, no additional SubDrive/MonoDrive
maintenance is required."
Wi-Fi MODULE
The Wi-Fi module has been tested and found to comply with part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference. This equipment generates,
uses, and can radiate radio frequency energy for limited periods (approx. 15 min.) and, if the drive
is not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
4

Declaration of Conformity

Model Description
A 3Ror/outdoor)
MonoDrive Connect N3R
SubDrive15 Connect N3R
MonoDriveXT Connect N3R
SubDrive20 Connect N3R
SubDrive30 Connect N3R
SubDrive50 Connect N3R
E184902