Fuse/Circuit Breaker And Wire Sizing - Franklin Electric SubDrive15 Manuel Du Propriétaire

Service Entrance
Panel
Use the service
entrance panel
ground ONLY.

Fuse/Circuit Breaker and Wire Sizing

The Listed fuse/Listed circuit breaker size and maximum allowable wire lengths for connection to the SubDrive/
MonoDrive are given in the following tables:
Table 1: Circuit Breaker Sizing and Maximum Input Cable Lengths (in Feet)
Based on a 3% voltage drop
Listed Fuse /
Model Family Listed Circuit
Breaker Amps
15
MonoDrive C
15
15
SubDrive15 C
15
20
MonoDriveXT C
20
20
SubDrive20 C
20
25
SubDrive30 C
25
40
SubDrive50 C
40
XXXX Highlighted Numbers denote wire with 194 °F (90 °C) insulation only
NOTE:
Not to be used on a Ground Fault Circuit Interrupter (GFCI). If using an externally regulated generator, verify that
the voltage, Hertz and idle speed are appropriate to supply the drive.
DO NOT run ground wire separate.
Motor ground wire MUST be bundled with motor wires.
AWG Copper Wire Sizes, 167 °F (75 °C) Insulation Unless Otherwise Noted
Nominal
Input
14 12
Voltage
208 80 125
230 95 150
208 70 110
230 85 135
208 - 85
230 - 105
208 - -
230 - 85
208 - -
230 - -
208 - -
230 - -
SubDrive/MonoDrive Connect
10 8 6 4
205 315 500 790
250 385 615 970
185 280 450 710
225 345 550 865
140 220 345 550
175 265 425 670
115 180 285 450
140 220 345 550
95 145 235 370
115 180 285 455
- - 150 235
- 115 185 290
Pump
Motor
3 2 1 1/0
980 1290 1635 -
1200 1580 2000 -
880 1160 1465 -
1075 1415 1795 -
680 895 1135 -
835 1095 1390 -
555 730 925 -
680 895 1130 -
460 605 765 -
560 740 935 -
295 385 490 610
360 470 600 745
2/0
-
-
-
-
-
-
-
-
-
-
735
895
15