Franklin Electric SubDrive15 Manuel Du Propriétaire page 27

Auxiliary Input
The AUX IN terminal supports a dry-contact 24 VDC digital input to control the SubDrive/
MonoDrive unit. This terminal can be wired using the internal 24 VDC supply or an external 24 VDC
supply. When using an external 24 VDC supply, the signal common of the external supply must be
connected to the AUX INPUT (-) terminal of the SubDrive/MonoDrive controller.
(+): 24 VDC switched input
Internal 24 VDC Supply
WET SENSOR
(+24)
-OR-
TRANSDUCER
(+24)
External 24 VDC Supply
Refer to the Advanced Setup section for more information about configuring this input.
(-): Signal Common for 24 VDC signal
SubDrive/MonoDrive Connect
AUX INPUT
AUX INPUT
AUX INPUT
(+)
(+)
(-)
27