Lifting Onto The Roof; Fixing The Collector; Making The Collector Connections; Fitting The Collector Sensor Well - Stiebel Eltron SOL 27 BASIC Utilisation Et Installation

10.2 Lifting onto the roof

You can pull the collector onto the roof over a ladder. To do this,
place a rope around the collector frame.
Never secure the rope to the collector connections.
2
1
1 Rope
2 Collector

10.3 Fixing the collector

Install the collector in accordance with the installation instructions
for the fixing system being used.
Damage to the appliance and the environment
If there is strong sunlight, the collectors should be cove-
red with opaque material before commissioning.

10.4 Making the collector connections

Interconnect the collectors. The collector connection on the left
side has a male thread, and the collector connection on the right
side has a union nut.
1
2

10.5 Fitting the collector sensor well

The correct connection of the collector sensor is crucial to the
correct function of the solar thermal system.
Assemble the collector sensor well at the collector flow, which is
the warmest place of the collector array.
1 Roof outlet (corrugated hose)
2 Thermal insulation
3 Collector sensor well
4 Threaded fitting
5 Heat conducting paste
6 Temperature sensor
f Coat the collector sensor of the control unit with heat
conducting paste.
f Insert the collector sensor into the collector sensor well until
it bottoms.
f Secure the sensor lead, with cable ties for example.
Never adjust or twist the fitted connections.
1 2
3
4
5 6