Physical Installation; Mounting The Drive - Franklin Electric SUBDRIVE CONNECT PLUS Manuel Du Propriétaire

PHYSICAL INSTALLATION

Mounting the Drive

Mounting the Drive
CAUTION
Risk of bodily injury or damage to drive or other equipment.
• The drive must be mounted on a structure such as a wall or post capable of supporting
the weight of the unit. Refer to Applications on page 8 for drive weight.
• Install VFD on a non-combustible surface.
• Ensure suitable mounting hardware is used when installing the drive.
• Do not install the drive on unreinforced drywall.
• Use two persons when lifting the drive for transport or installation. If using lifting equip-
ment, it must be in good condition and rated for at least 5 times the weight of the drive.
• Wear protective gloves while installing the drive to guard against sharp edges.
The mounting location should have nearby access to an appropriate electrical supply and access to the
motor wiring. Refer to "Electrical Installation" on page
Use lag screws or bolts appropriate for supporting the weight of the drive.
IMPORTANT: Do not drill holes in the drive.
1. Mount the drive using all three keyhole slots on the top side of the enclosure.
IMPORTANT: At least two keyhole screws at the top must attach to a solid structure such as a stud
or brace.
2. Secure the three additional mounting holes on the bottom.
IMPORTANT: All six screw hole locations should be used to ensure the drive is securely mounted.
16
19.