Franklin Electric SUBDRIVE CONNECT PLUS Manuel Du Propriétaire page 49

NOTICE
Risk of damage to drive, or malfunction can occur due to improper installation.
• Frame 2 stirring fans direct airflow towards the circuit boards.
• Frame 3 stirring fans direct airflow away from the circuit boards.
• The fan's airflow direction is embossed on the side of the fan.
External Fans Replacement
External fans push air over the cooling fins of the Power Board
heat sink. They connect to the Control Board at connectors (4).
1. Remove power from the drive and wait 5 minutes.
2. Disconnect the incoming power from terminal block (2). Install
protective wire nuts onto the end of each wire.
3. Disconnect the motor wires from terminal block (3). Install
protective wire nuts onto the end of each wire. This allows for
unobstructed access to the External Fans assembly.
4. Disconnect the External Fans assembly wires from terminal
block (4).
5. Remove the screws from the External Fans assembly.
6. Slide out the existing External Fans assembly and set aside.
Slide in the replacement External Fans assembly. Secure with
the screws removed in step 5. Tighten to 10 in-lbs (1.1 Nm).
7. Route the wires to terminal block (4). Connect the red fan wire
to (+), the black fan wire to (-), and the blue fan wire to (P)
for each fan. Tighten to 3 in-lbs (0.35 Nm).
Always verify that any replacement fans are spinning after installa-
tion of the Fan Replacement Kit.
1. Power up the drive.
2. Visually verify that the fans are spinning.
3. Power off the drive.
4. Replace the cover.
Firmware Update Procedure
There are two ways to update the drive's firmware. One method is to use a portable USB device, and
the other method is by using the FE Connect — SubDrive Connect Plus mobile app.
D D e e t t e e r r m m i i n n e e C C u u r r r r e e n n t t F F i i r r m m w w a a r r e e V V e e r r s s i i o o n n
Using the right arrow push button on the Control Board, navigate to the QR Code screen, refer to
Navigation" on page 29. This screen displays the current software version and the drive/motor voltage.
A A p p p p F F i i l l e e P P r r e e p p a a r r a a t t i i o o n n
Use the mobile app to download the latest firmware to the drive. Go to the M M e e n n u u screen and press the
button labeled H H a a r r d d w w a a r r e e . Follow the instructions on the app screen. Refer to
cation" on page 39 to pair the mobile device to the drive.
Periodic Maintenance
"Menu
"FE Connect Mobile Appli-
MAINTENANCE
49