Service Information; Drawer Front And Strap Pull Replacement - Stryker 4821 Manuel D'utilisation Et D'entretien

Michael graves with stryker bedside cabinet

Masquer les pouces

Table des Matières

Les langues disponibles

DROP LEAF REPLACEMENT

Tools Required:

• #2 Phillips Screwdriver

Procedure:

1 .

Using a #2 Phillips screwdriver, remove the two screws that secure the drop leaf support to the drop leaf .

2 .

Using a #2 Phillips screwdriver, remove the seven screws that secure the drop leaf to the hinge .

Note: Hold the drop leaf to support it while removing the screws .

3 .

Reverse steps to reinstall .

4 .

Verify proper operation of the unit before returning it to service .

DROP LEAF HINGE REPLACEMENT

Tools Required:

• #2 Phillips Screwdriver

Procedure:

1 .

Using a #2 Phillips screwdriver, remove the two screws that secure the drop leaf support to the drop leaf .

2 .

Using a #2 Phillips screwdriver, remove the seven screws that secure the drop leaf to the hinge . Set the drop leaf

aside .

Note: Hold the drop leaf to support it while removing the screws .

3 .

Using a #2 Phillips screwdriver, remove the seven screws that secure the hinge to the cabinet assembly .

4 .

Reverse steps to reinstall .

5 .

Verify proper operation of the unit before returning it to service .

DRAWER FRONT AND STRAP PULL REPLACEMENT

Tools Required:

• #2 Phillips Screwdriver

Procedure:

1 .

Open the drawer midway .

2 .

Using a #2 Phillips screwdriver, remove the two screws, located on the inside of the drawer box, that secure the

drawer front to the drawer .

3 .

Using a #2 Phillips screwdriver, remove the two screws that secure the strap pull handle to the drawer .

4 .

Reverse steps to reinstall .

5 .

Verify proper operation of the unit before returning it to service .

www.stryker.com