Stryker 4821 Manuel D'utilisation Et D'entretien page 8

English
RAISING THE DROP LEAF
To raise the drop leaf, lift the drop leaf by the end handle until the support
arm locks into place as shown in Figure 1 .
WARNING
Use caution when raising and lowering the drop leaf to avoid pinching your
fingers between the drop leaf and support arm, cabinet, and/or unit top .
LOWERING THE DROP LEAF
To lower the drop leaf, pull the support arm ring (Figure 2) to release and
lower the drop leaf down to vertical .
WARNING
Use caution when raising and lowering the drop leaf to avoid pinching your
fingers between the drop leaf and support arm, cabinet, and/or unit top .
REMOVING THE WASTEBASKET
To remove the wastebasket, remove all items, then lift up on both corners
on the back edge of the wastebasket until it releases from the two knobs
as shown in Figure 3 .
INSTALLING THE WASTEBASKET
To install the wastebasket, place the keyhole slots of the wastebasket over the two knobs and push down on top edge
until it snaps into place as shown in Figure 4 .
Note: The wastebasket
is not intended for fluids .
Return To Table of Contents
1-6
Operation Guide
Figure 3: Remove Wastebasket
4821-009-001 REV C
Figure 1: Raise Drop Leaf
Figure 2: Lower Drop Leaf
Figure 4: Install Wastebasket
www.stryker.com