Onkyo MD-121 Manuel D'instructions page 34

1
-B Y /O N
S TA N D
ST AN D-
2
a
a Rear side
Côté arrière
Rückseite
b Record-protect tab
Languette de protection d'enregistrement
Löschschutzlasche
c Record-protect hole
Trou de protection d'enregistrement
Löschschutzöffnung
d Front side
Côté avant
Vorderseite
34
D -1 21
R D ER M
C R EC O
M IN ID IS ISM
ME CH AN
AD IN G
DI SC LO
rE JE CT
BY IN PU T
A D1 D2
DI SP LA Y
b
c
d
* Insert an MD with its label side up into the MD
recorder in the direction indicated by the arrow.
YE S
ED IT/ NO
* Insérer un MD avec son étiquette vers le haut dans
l'enregistreur de MD, dans la direction indiquée par la
flèche.
* Eine MD mit der Beschriftung nach oben in
Pfeilrichtung in den MD-Recorder einschieben.
INPUT
A D1 D2
Protect Recordings from Accidental Erasure
You can make your MDs impossible to be recorded on by sliding
the record-protect tab on the MDs to open the record-protect hole.
To make the MDs recordable again, return the record-protect tab.
Check the Contents of Recording Immediately
Immediately after recording is stopped, press the n button. The
playback of the recording starts from where the recording was
started.
To playback from the beginning of the MD, immediately after
recording is stopped, press the e button again. Then, press the
n button to start playback.
If you have left the MD-121 unused since recording has stopped,
both the playing track number indication in the track number display
and that in the time display should be flashing. Pressing the PLAY
button in this state causes the track whose track number indicators
are flashing to play.
Storage Period of Backup Data
The recorded contents will be backed up inside the MD-121 even if
the MD recorder's power cord is accidentally unplugged or if a
power failure occurs before they are stored to the disc (when
is lit) or when they are being stored to the disc (when
TOC
is flashing). You can restore the data which was backed up during
such an accident or power failure by pressing the STAND-BY/ON
button after plugging in the power cord or immediately after the
power failure is solved. Note, however, that the period in which the
backup data is stored is approx. only 2 weeks. So, especially after a
power failure, perform the above procedures as soon as possible
after power is restored.
TOC