Controller - JUMO eTRON M 100 Notice De Mise En Service

Parameter Meaning

5.3 Controller

Ex-factory, the controller is set to "Cooling".
For the special "Cooling + Heating" function, the fan relay is used for heating.
Contr. type (tyPe)
0 : Cooling contr.
1 : Freezing contr.
2 : Cooling+Heating ... switches the relays
Setpoint
The process is controlled to this temperature.
2009-04-10
with above/below measured value (e.g. probe break)
... switches the relay off.
... switches the relay on.
and off.
5 Parameter level
Value range
from...factory-set...to
0, 1, 2
... 0.0 ...
in °C or °F
15