Process Value Display (After Switch-On); Changing Over To The Parameter Level (Inhibited By A Code); Selecting The Parameter, Editing (Navigation Principle) - JUMO eTRON M 100 Notice De Mise En Service

2009-04-10
h
Apply the supply voltage, all segments light up five seconds long (for testing the segments).
When everything has been connected up correctly to the instrument, it will show the current temperature at analog input 1.
With the Data logger option,
If an alarm/error message appears, see Chapter 8 "Alarm and error messages".

4.2 Process value display (after switch-on)

The parameter di.P is used to set the process value to be displayed.
v
Chapter 5.7 "LC display"
If the process value will be changed by the keys

4.3 Changing over to the parameter level (inhibited by a code)

The instrument parameters are factory-set at the parameter level, and are inhibited by a code.
All parameters can be edited within the value range, as described in the table below.
h
Press the key for 3 seconds,
h
Use the and keys to set the code for the parameter level
(factory-set: code 72, can be altered through the setup program).
The longer the key is pressed, the faster the value will change.
h
Acknowledge with
The first parameter name and value will appear alternately.

4.4 Selecting the parameter, editing (navigation principle)

h
The and keys are used to select all parameters (upwards or downwards within the parameter table).
4 Commissioning the instrument
is shown briefly after switching on.
and the device switches back automatically after timeout.
will appear alternately.
.
10