Inserting The Filters; 230 V Electrical Connection; Function Test / Remote Control Mounting - Truma Aventa eco Mode D'emploi / Instructions De Montage

Securing the air distributor
Connect cable from air distributor to electronic module.
Fig. 26
Screw air distributor (arrow in direction of travel) to bracket
with 6 screws M6 x 12 mm.
The covering tape that is available as an accessory can
be used to compensate for the gap between the air dis-
tributor and the roof.
Fig. 27
If the screws are used more than once (e.g. after re-
moval) they must be coated with low-strength screw
sealant again (e.g. Loctite) or the screws provided as spare
parts used.

Inserting the filters

Insert filters into panels and attach to the air distributor.
Fig. 28
24
Fig. 29
Fig. 30

230 V electrical connection

The 230 V electrical connection must always be made
by an expert (in accordance with VDE 0100, part 721 or
IEC 60364-7-721, for example, in Germany). The instructions
shown here do not constitute a request to non-experts to
make the electrical connection, but serve as additional infor-
mation for an expert who is employed to do the work!
Connect the mains cable that has been routed to the connect-
ing point.
All cables must be secured with clamps!
An insulating device for providing all-pole insulation from
the mains with contact clearance of at least 3.5 mm must be
provided at the vehicle side for carrying out maintenance and
repair work.
Function test /
remote control mounting
Attach the mounting for the remote control in the required
location.
All device functions must subsequently be tested as de-
scribed in the operating instructions.
The installer must check that the condensation traps are clear
after installing the system.
The operating instructions must be handed over to the vehicle
owner.