Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation dimensions
1008
Fig. 8
195
(215)
530
Fig. 9
Clearance around the air conditioning system
The clearance around the external unit must be 20 mm at
the front and 100 mm at the side. At least 30 mm of clear-
ance must be left at the rear. Truma recommends clearance of
200 mm so that the exhaust air can blow out freely.
Fig. 10
The clearance around the air distributor must allow the air to
blow out without obstructions. The side clearance must be at
least 40 mm. The pivoting range of flaps and doors must be
taken into consideration.
Fig. 11
20
(in mm)
670
400
(380)
Air inlets / outlets
Fig. 12
Condensation traps
The condensation is led away via the roof of the vehicle.
Fig. 13
Right reserved to make technical changes!
Manufacturer's Warranty
(European Union)
1. Scope of Manufacturer's Warranty
As the Manufacturer of the unit, Truma undertakes a warranty
towards the Consumer that covers any material and/or manu-
facturing defects of the unit.
This Warranty is applicable in EU member states as well as in
Iceland, Norway, Switzerland and Turkey. A Consumer is the
natural person who was the first one to purchase the unit from
the Manufacturer, OEM or dealer and who neither resold the
unit in a commercial or self-employed professional capacity
nor did he or she install it for a third party in such a capacity.
The Manufacturer's Warranty covers any of the aforementioned
defects that occur within 24 months upon concluding the
purchase agreement between the seller and the Consumer.
The Manufacturer or an authorised service partner undertakes
to remedy such defects through subsequent fulfilment, i.e.
at its discretion either by repairing or replacing the defective
item. Any defective parts shall become the property of the
Manufacturer or the authorised service partner. If the unit is
no longer manufactured at the time of defect notification and
if replacement delivery has been opted for, then the Manufac-
turer may deliver a similar product.
If the Manufacturer remedies a defect under its warranty com-
mitment, the term of the Warranty shall not recommence anew
with regard to the repaired or replaced parts; rather, the origi-
nal warranty period shall continue to be applicable to the unit.
Only the Manufacturer itself and an authorised service partner
shall be entitled to conduct a warranty job. Any costs that oc-
cur in the event of a warranty claim shall be settled directly
between the authorised service partner and the Manufacturer.
Publicité
Chapitres
Table des Matières
