Installation - KERN ABT Serie Mode D'emploi

7.2.2 Installation

ABT-NM-BA-e-1622
• Attach the adapter cable holder. Peel
the protective sheet of adhesive of
the adapter cable holder, and stick it
on the back of the balance as shown
in the figure.
• Carrier of weighing plate, attach
weighing plate and circular screen in
order.
• Level balance with foot screws until
the air bubble of the water balance is
in the prescribed circle.
• When the key panel and the display
must be protected from dirt and wear,
place the cover over the key panel.
17