Stop Bit Settings; Input-Output Data Format Settings; Handshake Settings - KERN ABT Serie Mode D'emploi

15.5.4 Stop bit settings

1. The display changes from "io.S:****" to "S-S1". Pressing the [CAL] key changes the
display. The standstill display ( ) marks the current setting.
Display during setting
Setting specifics
2. Confirm your desired setting by pressing the [TARE] key.
3. To return to "io.S:****", press the [ON/OFF] key.

15.5.5 Input-output data format settings

1. The display changes from "io.F:****" to " F-dF1". Pressing the [CAL] key changes
the display. The standstill display ( ) marks the current setting.
Display during setting
Setting specifics
2. Confirm your desired setting by pressing the [TARE] key.
3. To return to "io.F:****", press the [ON/OFF] key.
Note: When set to data format 2, the balance will always send a process result
against commands from the computer.

15.5.6 Handshake settings

1. The display changes from "io.H:****" to " H-oFF". Pressing the [CAL] key changes
the display. The standstill display ( ) marks the current setting.
Display during setting
Setting specifics
2. Confirm your desired setting by pressing the [TARE] key.
3. To return to "io.H:****", press the [ON/OFF] key.
ABT-NM-BA-e-1622
S-S1
Stop bit, 1 bit
F-dF1
Data format 1. Data format 2.
Standard for- Not document-
mat ed
H-oFF H-Soft
Software
No handshake
handshake
S-S2
Stop bit, 2bit
F-dF2 F-dF3
Data format 3.
Not document-
ed
H-HArd
Hardware
handshake
F-dF4
Data format 4.
Not docu-
mented
H-tr
Timer
handshake
69