Evolution R210 CMS Instructions Originales page 4

Noise Emission
The noise emission values have been determined
according to noise test code given in EN 62841-1,
using the basic standards EN ISO 3744 and EN ISO
11201.
Warning: Wear hearing protection!
Handling
• Handle the machine with care,
allowing the machine to do the work.
• Avoid using excessive physical effort
on any of the machines controls.
• Consider your security and stability,
and the orientation of the machine during use.
Work Surface
• Consider the work surface material;
its condition, density, strength,
rigidity and orientation.
LABELS & SYMBOLS
(1.8)
WARNING: Do not operate this machine if
warning and/or instruction labels are missing
or damaged. Contact Evolution Power Tools for
replacement labels.
Note: All or some of the following symbols may
appear in the manual or on the product.
Manufacturing Date Code
The manufacturing date code is the first part of
the serial number, found on the motor housing
of the machine. Evolution serial numbers begin
with the abbreviation of the machine followed by
a letter. A = January, B = February and so on. The
following 2 numbers are the year of manufacture.
09 = 2009, 10 = 2010, etc. (Example of batch code:
XXX-A10)
(1.9)
Symbol Description
V Volts
A Amperes
Hz
Hertz
min Speed
-1
~ Alternating Current
n o
No Load Speed
Wear Safety Goggles
www.evolutionpowertools.com
Wear Ear Protection
Wear Dust Protection
Wear Safety Gloves
Read Instructions
EAC Certification
Triman - Waste Collection
Waste Electrical &
Electronic Equipment
INTENDED USE OF THIS
(1.10)
POWER TOOL
WARNING: This product is a Compound Mitre
Saw and has been designed to be used with
special Evolution blades. Only use accessories
designed for use in this machine and/or those
recommended specifically by Evolution Power
Tools Ltd.
WHEN FITTED WITH A CORRECT BLADE THIS
MACHINE CAN BE USED TO CUT:
• Wood, Wood derived products (MDF, Chipboard,
Plywood, Blockboard,Hardboard etc),
Wood with nails,
• 50mm mild steel box section with 4mm
wall at HB 200-220,
• 6mm mild steel plate at HB 200-220.
Note: Wood containing non galvanised nails or
screws, with care, can be safely cut.
4
Do Not Touch
CE Certification
& Recycling
Warning
Protection Class II
Double Insulated