EN
21
Acoustic Signal
The acoustic signal sounds:
Upon the appearance of a disturbance in 2 second intervals.
After completion of a centrifugation run and rotor standstill in 30 second intervals.
The acoustic signal is stopped by opening the lid or pressing any key.
The signal after completion of the centrifugation run can be activated or deactivated in the following manner, if the
rotor is at standstill:
Hold down the key
SELECT
After 8 seconds, SOUND / BELL appears in the display.
Set using the knob
OFF or ON.
Press the key
START / IMPULS
As confirmation, ok will be displayed for a short period.
22
Recall hours of operation
Recall hours of operation is only possible during rotor standstill.
Hold down the key
SELECT
After 8 seconds, SOUND / BELL appears in the display.
Press the key
once again.
SELECT
The centrifuge's hours of operation (CONTROL: ) are displayed.
Press the key
to exit the hours of operation recall.
STOP
46/102
for 8 seconds.
in order to store the setting.
for 8 seconds.
Rev. 07 / 05.2020
AB4600DEENFRIT