Entering Centrifugation Parameter; Programming; Programme Input/Alteration; Programme Recall - Hettich ROTOFIX 46 Mode D'emploi

EN
17

Entering centrifugation parameter

If no key is pressed for 8 seconds long after the selection or during the input of parameters, the previous
values will be shown in the display. The input of parameter then has to be executed again.

Select the RPM or RCF display with the key

Select the desired parameters using the button
In order to set continuous operation, the parameters t/min and t/sec must be set to zero with the
Continual running is represented in the display by the following symbol, "".

After input of all parameters, press the key
position #. As confirmation,  ok  will be displayed for a short period.
The data on the programme position # will be overwritten with every input of parameters and pressing of the
key .
START / IMPULS
18

Programming

18.1

Programme input/alteration

If no key is pressed for 8 seconds long after the selection or during the input of parameters, the previous
values will be shown in the display. The input of parameter then has to be executed again.

Select the RPM or RCF display with the key

Select the desired parameters using the button
In order to set continuous operation, the parameters t/min and t/sec must be set to zero with the
Continual running is represented in the display by the following symbol, "".

The parameter PROG STO can be selected using the button
the knob .

Press the button
START / IMPULS
displayed briefly as confirmation.
If the key
START / IMPULS
stored in the program place #.
The previous data in the program position is overwritten during saving.
18.2

Programme recall


Select the parameter PROG RCL using the button
.

Press the button
START / IMPULS

The parameters can be checked by pressing the button
To leave the parameter display press the button
44/102
. RCF values are displayed in > <.
RCF
SELECT
START / IMPULS
. RCF values are displayed in > <.
RCF
SELECT
in order to store the setting on the desired program position.  ok  is
is pressed without the parameter PROG STO being activated, the settings are always
SELECT
. The centrifugation data of the selected program position is displayed.
STOP
Rev. 07 / 05.2020
and set using the knob .
in order to store the adjustments on the programme
and set using the knob .
and the desired program position set using
SELECT
and set the desired program position using the knob
.
SELECT
or press no button for a period of 8 seconds.
knob.
knob.
AB4600DEENFRIT