Ks100 Keyswitch (Optional); Fl100 Flasher With Integrated Antenna (Optional); Gtx4 Radio Transmitter; Installation - Nice MhouseKit GD0N Instructions Et Avertissements Pour L'installation Et L'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4
2.3.3 – KS100 keyswitch (optional)
The KS100 key-operated two-position selector switch enables door con-
trol without using the radio transmitter. It is equipped with internal light for
locating in the dark.
There are two commands, which depend on the direction of rotation
of the key: "OPEN" and "STOP"; then the key, which is spring loaded,
returns to the centre position.
TABLE 3
List of small parts for KS100
HI LO 4X9.5 screw
3.5X25 self-tapping screw
s 5 c nylon screw anchor
5
STEP 3
The installation must be carried out by qualified and skilled
personnel in compliance with the directions provided in chapter
1 "WARNINGS".

3.1 - PRELIMINARy CHECKS

GD0N must not be used to power a door that is not efficient and
safe. It cannot solve defects resulting from incorrect installation or
poor maintenance of the door.
CAUTION: incorrect installation can cause serious damage.
Before proceeding with the installation you must:
• Make sure that the door movement does not hinder roads or
public footpaths.
• After the motor has been installed, remove unnecessary cables
or chains and turn off any unneeded equipment.
2.3.4 – FL100 flasher with integrated antenna (optional)
The flashing light is controlled by the control unit and signals danger when
the door is moving. Inside the flashing light there is also the aerial for the
radio receiver.
List of small parts for FL100
4.2X32 self-tapping screw
s 6 c nylon screw anchor
6
Q.ty
Pcs 2
2.3.5 – GTX4 radio transmitter
Pcs 4
The radio transmitter is used for the remote control of the door opening
and closing manoeuvres. It features four buttons that can all be used for
Pcs 4
the 4 types of command to a single automation unit, or to control up to 4
different automation units.
The transmission of the command is confirmed by the LED [A]; an eyelet
[B] allows them to be hung on a keyring.
7

INSTALLATION

• Make sure that the weight and dimensions of the door fall within
the specified operating limits (Chapter 3.1.1). If they do not, GD0N
cannot be used.
• Make sure that the structure of the door is suitable for automa-
tion and in compliance with regulations in force.
• Make sure that there are no points of greater friction in the open-
ing or closing stroke of the door.
• Make sure that the mechanical structure of the door is sturdy
enough and that there is no risk of it derailing out of the guides.
• Make sure that the door is well balanced: it must not move by
itself when it is placed in any position.
• Make sure that the installation area is compatible with the size of
the gearmotor and that it is safe and easy to release.
• Make sure that the mounting positions of the various devices
are protected from impacts and that the mounting surfaces are
TABLE 4
A
Q.ty
Pcs 4
Pcs 4
B
English – 7

Publicité

Table des Matières
loading

Table des Matières