Ks100 Key-Operated Selector Switch (Optional); Fl100 Flashing Light With Incorporated Aerial (Optional); Gtx4 Radio Transmitter; Installation - Nice MhouseKit GD1N Instructions Et Avertissements Pour L'installation Et L'utilisation

2.3.3 – KS100 key-operated selector switch (optional)
The KS100 key-operated two-position selector switch enables door con-
trol without using the radio transmitter. It is equipped with internal light for
locating in the dark.
There are two commands, which depend on the direction of rotation
of the key: "OPEN" and "STOP"; then the key, which is spring loaded,
returns to the centre position.
TABLE 5
List of small parts for KS100
HI LO 4X9.5 screw
3.5X25 self-tapping screw
s 5 c nylon screw anchor
5
2.3.4 – FL100 flashing light with incorporated aerial (optional)
The flashing light is controlled by the control unit and signals danger when
the door is moving. Inside the flashing light there is also the aerial for the
radio receiver.
TABLE 6
List of small parts for FL100
4.2X32 self-tapping screw
s 6 c nylon screw anchor
STEP 3
The installation must be carried out by qualified and skilled
personnel in compliance with the directions provided in chapter
1 "WARNINGS".
3.1 – PRELIMINARy CHECKS
GD1N and GD10N must not be used to power a door that is not
efficient and safe and cannot solve defects resulting from incor-
rect installation or poor maintenance of the door itself.
WARNING: incorrect installation could cause serious damage.
Before proceeding with the installation you must:
• Make sure that the door movement does not hinder roads or
public footpaths.
• After the motor has been installed, remove unnecessary cables
or chains and turn off any unneeded equipment.
• Make sure that the weight and dimensions of the door fall within
the specified operating limits (Chapter 3.1.1). If they do not, GD
cannot be used.
6
Q.ty
Pcs 2
Pcs 4
2.3.5 – GTX4 radio transmitter
Pcs 4
The radio transmitter is used for the remote control of the door opening
and closing manoeuvres. It features four buttons that can all be used for
the 4 types of command to a single automation unit, or to control up to 4
different automation units.
The transmission of the command is confirmed by the LED [A]; an eyelet
[B] allows them to be hung on a keyring.
7
Q.ty
Pcs 4
Pcs 4

INSTALLATION

• Make sure that the structure of the door is suitable for automa-
tion and in compliance with regulations in force.
• Make sure that there are no points of greater friction in the open-
ing or closing stroke of the door.
• Make sure that the mechanical structure of the door is sturdy
enough and that there is no risk of it derailing out of the guides.
• Make sure that the door is well balanced: it must not move by
itself when it is placed in any position.
• Make sure that the installation area is compatible with the size of
the gearmotor and that it is safe and easy to release.
• Make sure that the mounting positions of the various devices
are protected from impacts and that the mounting surfaces are
sufficiently sturdy.
• Make sure that the mounting surfaces of the photocells are flat
and that they enable the proper alignment between TX and RX.
• Pay attention in particular to the methods for securing the head
of the guide and the brackets to the ceiling. The head of the guide
will have to bear all the strain of opening and closing the door; the
ceiling-mounted brackets will have to bear all the weight of GD. In
A
B
English – 7