Gd0N Electromechanical Gearmotor; Ph00 Photocells (Optional) - Nice MhouseKit GD0N Instructions Et Avertissements Pour L'installation Et L'utilisation

2
a
e
i
2.3.1 – GD0N electromechanical gearmotor
GD0N is an electromechanical gearmotor consisting of a 24V direct cur-
rent motor. It features a mechanical release mechanism with cord that
allows you to move the door manually in the event of a power failure.
The gearmotor is fixed to the ceiling with the relative mounting brackets.
The control unit actuates the gearmotor and provides for the control of the
supply of the different components; it features an electronic board with
incorporated radio receiver.
The control unit can actuate the gearmotor with two speeds: "slow" or
"fast".
The three P1, P2 and P3 buttons [B] and the corresponding LEDs are
used to program the control unit.
A numbered terminal block is present for the electrical connections [A].
A LED status signal is present in correspondence with the STOP input.
Hookup to the mains couldn't be easier - simply fit the plug into a mains
socket.
List of small parts for a GD0N
M6 self-tapping nuts
M6 x14 screws
6.3x38 tcei screws
4.2x9.5 screws
6x18 screws
R05 washers
Cable membrane
Mechanical stops
6 – English
b
f
l m
TABLE 1
Q.ty
Pcs 4
Pcs 2
Pcs 4
Pcs 2
Pcs 1
Pcs 2
Pcs 1
Pcs 2
c
g
n
3
B
2.3.2 – PH00 photocells (optional)
The pair of PH00 wall-mounted photocells, once they are connected to
the control unit, enables the detection of obstacles found on the optical
axis between the transmitter (TX) and the receiver (RX).
TABLE 2
List of small parts for PH00
HI LO 4X9.5 screw
3.5X25 self-tapping screw
s 5 c nylon screw anchor
d
h
o
A
Q.ty
Pcs 4
Pcs 4
Pcs 4