Trouble Shooting Guide - JUKI MO-735 Manuel D'instructions

Trouble shooting guide

Problem
The machine does not
sew:
Fabric does not feed
evenly
Thread breaks
Needles break
Skipped stitches
• Presser foot pressure is too low.
Poor stitch formation
Seams flute or wave,
especially when sewing
knits
Seams pucker
Fabric edges curl
Thread loops are too
Loose
C a u s e
• Looper or cloth plate cover is open.
• The main switch is not on.
• The machine is not plugged in.
• Differential feed is wrongly adjusted.
• Presser foot pressure is too low.
• Lower or upper knife is blunt or wrongly positioned.
• Thread tension is too tight for the thread being
used.
• The machine is not threaded correctly.
• Needles are incorrectly inserted.
• Wrong needles.
• Needles are bent or blunt, points are damaged.
• Needles are not inserted correctly.
• Fabric was pulled while sewing.
• Needles are bent or blunt.
• Wrong needles used.
• Threads are not correctly between the tension
dials.
• Thread has got caught.
• Machine is incorrectly threaded.
• Fabric was pulled while sewing.
• Presser foot pressure is too tight.
• Differential feed is set incorrectly.
• Needle thread tension is too tight.
• Differential feed is set incorrectly.
• Too much fabric is in the stitch.
• Thread tension is too tight.
• Stitch selection lever is on roll hem.
• Too little fabric in the stitch.
S l o t u o i n
• Close the looper or the cloth plate cover.
• Switch machine on. (Main switch to "I")
• Insert plug into main socket.
• Check the differential feed setting.
• Adjust the presser foot pressure.
• Replace the lower or upper knife.
• Reduce thread tension.
• Check the threading.
• Insert needles fully into needle clamp with flat
side to the back.
• Use needle system 130/705H.
• Replace needles.
• Insert needles fully into needle clamp with flat
side to the back.
• Guide fabric gently with both hands.
• Replace the needles.
• Use needle system 130/705H.
type JLx2 for cover and chainstitch.
• Increase presser foot pressure.
• Check if thread is lying between tension discs.
• Raise the presser foot and pull the thread.
• Check threading path of each thread.
• Check threading path of each thread.
• Guide fabric gently.
• Reduce presser foot pressure.
• Adjust differential feed to N - 2.
• Reduce the needle thread tension.
• Adjust differential feed to 0.7 - N.
• Reduce cutting width.
• Reduce thread tension.
• Set selection lever to overlock.
• Increase the cutting width.
Page
14
12
9
19
22
60
41,54
33,46
15
15
16
15
--
15
15
22
24
24
33,46
33,46
--
22
19,20
41,54
19,20
18
41,54
21
18
62