Danger Warning Decals; Instructions; Machine Start-Up; Crossover Angle - Corghi PW IW 6 Manuel D'utilisation

oPEraTING INSTrUCTIoNS
a) Check in each head 1 fig.7 that the oil reaches the level indicated by the indicator light 2 fig.6.
To top-up, unscrew the cap 3 fig.6.
b) Turn on the machine using the main switch 4 fig.8.
c) Set the required speed by using the keypad located on the intelli-wind 5 fig.10 (for more informa-
tion, consult the intelli-wind) manual after preselecting the crossover angle (1 or 2).
Based on the type of yarn, winding can be done with the crossover angle 1 (16°) or 2
(13°).
Each head is equipped with a lever 8 fig.6 that is used to make this selection.
This operation is performed with the head operating. Greater interweaving 1 (16°) is
normally used with thin and slippery yarn.
Speed is expressed in metres per minute and can be adjusted using intelli-wind (for more
information, consult the specific manual).
To obtain regularly-formed cones, never make adjustments while the cone is being formed
(speed~crossover angle~braking~waxing~rotation direction~different threading).
Do not form cones that are too soft that, sagging due to their weight, could intersect the
yarn guide 6 fig.6 and cause the yarn to break and deform the yarn guide itself.
User manual PW IW 6" 8" 10"

Danger warning decals

During all working procedures, keep hands far away from the yarn
guide and roller to prevent crushing accidents.
During all working procedures, keep hands far away from the
feeder to prevent abrasions.

machine start-up

Crossover angle

Speed

General hints

UK
33