Overview Menu Groups - Helios EUR EC Instructions D'installation Et D'utilisation

Installation and Operating Specification EUR EC
8.5

Overview menu groups

Main menu
Info
Start up
Setting
Protocol
Base setup
Controller Setup
IO Setup
Limits
Timer
Diagnostic
MODBUS Slave
MODBUS Master
L-BAL-E274-GB 1914 Index 003
Possible settings
Display measured actual values, selected setpoints, modulation, etc.
Settings cannot be made in this menu group.
PIN input for reset to initial settings and to protect settings.
Setting the menu language.
Display in SI units or Imperial units (US)
Complete re-start of the device.
Display of the set mode, software version, etc.
Settings for Operation, Setpoint, Pband, Min. Speed, Max. Speed, etc.
Display and query of events / malfunctions.
Setting of the desired mode, configuration of signal and sensor inputs.
Activation control circuit 2.
Activate set protection, save user settings.
Activate alarm message in the event of a sensor fault.
Activate limitation of modulation via digital input or timer of time switch.
Configuration of control parameters, group control.
Configuration and function assignment for: analogue outputs, digital inputs, relay out-
puts.
Limit messages depending on modulation, setting signal or sensor signal, offset to
setpoint.
Integrated time switch with programmable timer functions.
Clock fine adjustment
Current operating states of the device.
Addressing and configuration of the MODBUS Slave interface.
Start automatic addressing of members.
alternatively
Manual input of number of members.
Part.-No.
25/117
Controls and Menu