Helios EUR EC Instructions D'installation Et D'utilisation page 147

Installation and Operating Specification EUR EC
Setting
15 %
Min. Speed
Setting
100 %
Max. Speed
Setting in operation
After installation is completed, only the "Setting direct" or "Setting Step" setting is visible in the "Info" menu
group. All other menus are protected by a PIN.
Info
50 %
Setting direct
Info
5
Setting Step
Switching over to the protected "Info" menu group takes place automatically after approximately 15
minutes if no key is pressed.
Possibilities for early activation of PIN protection:
Select the "Info" menu group and confirm with the P key.
•
• Press the
displayed.
Execute the "Reset" function in the "Start" menu group.
•
• By switching the mains voltage off and then on again.
|
Input PIN 0010
50 %
▼ + ▲ =
Setting direct
5
Setting Step
L-BAL-E274-GB 1914 Index 003
Min. Speed
Setting range: 0... "Max. Speed"
Factory setting: 15 %
Max. Speed
Setting range: 100 % - "Min. Speed"
Factory setting: 100 %
1.02
Setting direct (at Number steps: 0
Setting range: Min. Speed - Max. Speed
Factory setting: 50 %
The value set by the ▼ ▲ keys is accepted and executed directly (P key without
function).
Setting step (at Number steps: 1 - 5
Setting range: 0 - programmed number steps
Factory setting: 0
| |
Esc key combination several times until the "Setting direct" or "Setting Step" menu is
|
exit the protected area
→
→
- - - - -
| |
Esc
PIN input
"Base setup")
"Base setup")
→
→
0010
P
PIN input
adjust PIN 0010
Part.-No.
29/117
Programming
→
Start up
Setting
Protocol
P
Base setup
Controller Setup
IO Setup