Base Setup 4.01; Setting For Operation Modes 4.01 - Helios EUR EC Instructions D'installation Et D'utilisation

Installation and Operating Specification EUR EC
9.3.2 Setting for operation modes
4.01
Pressure control, Setting Setpoint in Pa
4.02
Pressure control setpoint depending on outdoor temperature
Settings for controller output with function
members menu).
Main menu
Start up
Setting
Protocol
Base setup
Controller Setup
Setting
250 Pa
Setpoint1
Setting
- - - - -
Set Internal2
Setting
250 Pa
Pband
Setting
15 %
Min. Speed
Setting
100 %
Max. Speed
Setting
OFF
Manual mode
Setting
100 %
Speed manual
L-BAL-E274-GB 1914 Index 003
4.01 ... 4.02
| |
2A (by analogue signal
Setting
Setpoint1
Setting range: in measuring range of sensor
Factory setting: 250 Pa
Set Internal2
Setting "Setpoint 2" e.g. reduced value for night operation.
Switch over Setpoint 1/2 over external contact (display as long as noch allocation is
| |
carried out: - - - - - IO Setup).
Pband
Narrow control range = Short control times
Wide control range = Longer control times and more stable control
Setting range: in measuring range of sensor
Factory setting: 250 Pa
Min. Speed
Setting range: 0... "Max. Speed"
Factory setting: 15 %
Max. Speed
Setting range: 100 %... "Min. Speed"
Factory setting: 100 %
Manual mode
"OFF" = automatic control as function of the set parameters (Factory setting)
"ON" = automatic control without function, speed setting in menu "Speed manual"
Speed manual
Manual speed setting without influence by the external signal.
Activation by menu "Manual mode" or external contact at digital input (
Setting range: 0...100 %
Factory setting: 100 %
For information about deactivated regulation the adjusted value for manual speed is
indicated alternating with the actual value.
Part.-No.
38/117
IO Setup, by MODBUS
"Min. Speed"... "Max. Speed"
Programming
IO Setup).