Programming; Speed Controller; Speed Controller With Setting By External Signal; Base Setup - Helios EUR EC Instructions D'installation Et D'utilisation

Installation and Operating Specification EUR EC

9 Programming

Display in SI units or Imperial units (US)
The following description is for display in SI units (factory setting). The appropriate conversion factors
must be observed when switching over to Imperial units (US) (
9.1

Speed controller

9.1.1

Speed controller with setting by external signal

Settings for controller output with function
members menu).

Base setup

Main menu
Setting
Protocol
Base setup
Controller Setup
IO Setup
Base setup
1.01
Mode
Base setup
0 - 10V
E1 Analog In
Base setup
OFF
E2 Function
Base setup
- - - - -
E2 Analog In
Setting for operation
Main menu
Setting
Protocol
Base setup
Controller Setup
IO Setup
L-BAL-E274-GB 1914 Index 003
1.01 , 1.02
1.01
Base setup
Mode
Factory setting Mode:
E1 Analog In
Selection: 0 - 10V, 0 - 20 mA, 4 - 20 mA (Inverting, E1 BUS Modus
Factory setting: 0 - 10 V
E2 Function (only for special applications)
Analog input 2 "E2" factory set at "OFF".
For operation with a second setting signal and switch over by potential-free contact: E2
Function = Ext. Setpoint (1E)
Necessary function for digital input: E1/E2 (4D)
For operation with a second signal and automatic control at the higher level: E2
Function = comparison E1 (4E).
E2 Analog In
Display as long as no function allocated:
Selection: 0 - 10 V, 0 - 20 mA, 4 - 20 mA (Inverting, E1 BUS Modus
Factory setting: 0 - 10 V
1.01
Setting
1.01
| |
2A (by analogue signal
1.01
|
- - - - -
Part.-No.
26/117
Programming
menu group Start / US Units).
IO Setup, by MODBUS
IO Setup)
IO Setup
|
IO Setup)