Speed Controller With Direct Setting By Keyboard - Helios EUR EC Instructions D'installation Et D'utilisation

Installation and Operating Specification EUR EC
9.1.2

Speed controller with direct setting by keyboard

Base setup
Main menu
Setting
Protocol
Base setup
Controller Setup
IO Setup
Base setup
1.02
Mode
Base setup
0
Number steps
Base setup
- - - - -
Step 1 value
Menu group "Setting" (only when needed)
Main menu
Setting
Protocol
Base setup
Controller Setup
IO Setup
Setting
50 %
Setting direct
Setting
0
Setting Step
L-BAL-E274-GB 1914 Index 003
1.02
Base setup
Mode
Mode selection:
Number steps
Selection: 0, 1, 2, 3, 4, 5
Factory setting: 0
Number steps: 0
In the factory setting "0" (without steps) the output frequency can be set directly with
the ▼ + ▲ keys (
Number steps: 1, 2, 3, 4, 5
The modulation value can be assigned to each step. The desired step is set with the ▼
▲ keys ( setting in operation).
The following menus become active depending on the selected step count. (Step not
| |
active = - - - - )
Step 1 value - 5
Setting range: 0...100 %.
Factory setting: - - - - - (Number steps 0)
Factory setting: 20 %, 40 %, 50 %, 60 %, 100 % (Anzahl Stufen 1 - 5)
Setting
Setting direct (at Number steps: 0
If the setting is to be made during operation directly with the ▼ + ▲ keys, no setting is
necessary here (
Setting range: Min. Speed - Max. Speed
Factory setting: 50 %
Setting step (at Number steps: 1 - 5
If the setting is to be made during operation directly with the ▼ + ▲ keys, no setting is
necessary here (
Setting range: 0 - setting nummber steps
Factory setting: 0
1.02
1.02
setting in operation).
"Base setup")
setting in operation 1.02
"Base setup")
1.02
setting in operation
Part.-No.
28/117
Programming
).
).