Procedure As For Start-Up (Without Wizard) - Helios EUR EC Instructions D'installation Et D'utilisation

Installation and Operating Specification EUR EC
The desired value is found using
or
and confirmed with
.
After setting the "language" and "mode"
the desired "nominal value "is set, fol-
lowed by the "control range".
Select respectively with the "Up" and
"Down" keys and confirm with "P".
The successful start-up is confirmed with "OK".
The device is now ready for operation. Then the control or the current actual value is displayed.
Extensive further settings can be made as required. See these instructions.
3. The first-time start-up wizard can be reactivated if desired.
To do this, press "Esc" (arrow "Up" and "Down" briefly together) until the "Start "menu is displayed.
With "P" you first go to the "PIN" selection.
Press "P" again. Now the code
the first-time start-up wizard, see section 3.
7.3

Procedure as for start-up (without wizard)

1. Turn on mains voltage
– Display:
(Function of display
2. Switch over between "Info" and "Main menu" with the "Esc" key combination
3. Menu group: Start
– Set the menu language if necessary (factory setting German = Language D).
– The display can be switched between SI units (US units = OFF) and imperial (US) units (US
units = ON).
4. Menu group: Base setup
– Set the desired mode (factory setting
– Further settings depend on the selected mode and the sensor / setting signal used.
5. Menu group: Setting
– Set the parameters for the control mode.
L-BAL-E274-GB 1914 Index 003
V E N T I L A T I O N
EUR EC
Art. Nr. 1347 002
230 V~, 50/60 Hz
0-10 V / max. 10 mA
tu = 0-40 °C
IP54
| |
1020 can be entered. Terminate again with "P". Now you are back in
controls and menu)
1.01
Part.-No.
19/117
Modus 1.01
Drehzahlsteller mit Steuersignal z.B. 0-10 V
Modus 1.02
Drehzahlsteller über Tasten
Modus 2.01
Temperaturregelung in °C
Modus 2.03
Temperaturregelung in °C mit Zusatzfunktion
Modus 2.04
Temperaturregelung in °C
Vergleich oder Mittelwert mit zwei Sensoren
Modus 2.05
Differenztemperaturregelung in °C
mit zwei Sensoren
Modus 4.01
Druckregelung in Pa
Enter
Modus 4.02
Druckregelung in Pa
mit Außentemperaturkompensation
Ein Druck und ein Temperatur Sensor
Modus 6.01
Luftgeschwindigkeitsregelung in m/s
Modus 8.01
Absolute-Feuchte Differenzregelung in g/kg
mit zwei Sensoren
= speed controller).
Start-up
+
Esc
Made in Germany