Operation With A Second Control Circuit - Helios EUR EC Instructions D'installation Et D'utilisation

Installation and Operating Specification EUR EC
Mode and signal to E1, E2
6.2

Operation with a second control circuit

The function for control circuit 1 is determined by selection of the mode. This influences the output
with function
A second control circuit with separate actual value measuring and separate output can be activated
additionally if required.
Control circuit 2 influences the output with function
Analog output "A2" (factory setting)
•
MODBUS Master interface
•
Operation with a second control circuit is not possible in the following modes:
1.01 1.02
,
The following modes which are pre-programmed to operation with a second sensor can be reprog-
rammed to operation with a second control circuit.
2.04 2.05
,
The second control circuit is activated by the "E2 function" for the second analogue input "E2" (
menu group "Base Setup").
L-BAL-E274-GB 1914 Index 003
| |
2A .
member menu
2.03 4.02
, ,
| |
8A .
IO Setup
Part.-No.
15/117
Select operation mode