Member Mobus Master - Helios EUR EC Instructions D'installation Et D'utilisation

Installation and Operating Specification EUR EC
[P] OK
Manual address
Switch on device
[P] OK
Manual address
Select address
[P] Next
Manual address
Addressing Error
[P] Next
9.14

Member MOBUS Master

After addressing, (manual or automatic) the members are then listed to the "MODBUS Master" menu
group.
Main menu
MODBUS Master
Fan 1 (2A)
Fan 2 (2A)
Fan 3 (2A)
[P] Enter
After selection with the ▼ ▲ keys, press the P-key to open the State menu of the member (menu
content depends on the type of member).
State menu member
Example: ECblue fan
Fan 1 (2A)
ECblue V13.05
Fan OK!
Speed [rpm 570]
Motorcurrent [A] 2.60
P=0W
[P] Edit
L-BAL-E274-GB 1914 Index 003
[ESC] Cancel
Connect device to voltage and switch on
"
4
Press the P key
"
[ESC] Cancel
Set the desired address with the
"
assigned).
5
Press the P key
"
Error message for unsuccessful addressing.
The function for activation by MODBUS is displayed after the address of the
member.
The same function is programmed initially for all members after addressing.
Control Signal (2A)
I.e. every member is activated by the output of control circuit 1.
[ESC] Info
← Device type and firmware version
← Operating state of the member
← Speed Actual value (1/min)
← Current consumption
Level=0% ← Power consumption and modulation of the device
[ESC] Menu
to perform addressing.
▼+▲
to perform addressing of more members.
|
.
Part.-No.
90/117
Programming
keys (higher than addresses already
|
1.