Maintenance - salmson IXENS Manuel D'installation Et Mise En Service

English
10

Maintenance

Safety
112
Have maintenance and repair work carried out by qualified skilled
personnel only!
We recommend that you have the pump serviced and checked by
Samson customer service.
DANGER! Risk of fatal injury!
There is a risk of fatal injury from electric shock when working on
electrical equipment.
• Work on electrical equipment may only be done by electricians
approved by the local electricity supplier.
• Before working on electrical equipment, switch it off and secure it
against being switched on again.
• Any damage to the connection cable of the pump should always be
rectified by a qualified electrician only.
• Never use an object to poke around the openings on the electronic
module or motor and never insert anything into the module or
motor.
• Follow the installation and operating instructions for the pump,
level control device and other accessories.
DANGER! Risk of fatal injury!
The permanently magnetised rotor inside the motor presents an
acute danger to persons with pacemakers. Non-observance results
in death or the most serious of injuries.
• Persons with pacemakers must follow the general behavioural
guidelines that apply for handling electrical equipment when
working on the pump.
• Do not open the motor!
• Only allow Salmson customer service to dismantle and install the
rotor for maintenance and repair work.
• Only allow persons who do not have a pacemaker to dismantle and
install the rotor for maintenance and repair work.
NOTE:
The magnets inside the motor do not pose a danger provided the
motor is completely mounted. As such, the pump assembly does not
pose a special danger to persons with pacemakers, who can safely
approach a Ixens without any restrictions.
WARNING! Risk of injury!
Opening the motor leads to high, suddenly occurring magnetic
forces. These can cause serious cuts, crushing injuries and bruises.
• Do not open the motor!
• Only allow Salmson customer service to dismantle and install the
motor flange and the bearing plate for maintenance and repair
work.
DANGER! Risk of fatal injury!
Failure to install safety devices on the electronic module or near
the coupling can cause electrical shock or contact with rotating
parts, potentially resulting in life-threatening injuries.
• After maintenance, all safety devices such as module covers or
coupling covers that were removed must be reinstalled!
CAUTION! Risk of property damage!
Danger of damage due to incorrect handling.
• The pump may never be operated without the electronic module
being installed.
Salmson 01/2017