Symbols In Graphics/Instructions; Display Modes - salmson IXENS Manuel D'installation Et Mise En Service

English
8.4

Symbols in graphics/instructions

Menu elements
Actions
8.5

Display modes

Display test
max
min
2
Fig. 35: Display test
8.5.1 Display status page
96
Chapter 8.6 "Operating instructions" on page 98 contains graphics
that illustrate the operating concept and provide instructions for con-
figuring settings.
In the graphics and instructions, the following symbols are used as
simple representations of menu elements or actions:
• Menu status page: Standard view on the display
12.3
• "One level down": A menu element that can be used to jump to a
4.1.0.0
lower menu level (e.g. <4.1.0.0> to <4.1.1.0>).
• "Information": A menu element that shows information about the
device status or settings that cannot be changed.
• "Selection/setting": A menu element that provides access to a
±
4.4.3.0
2.0.0.0
changeable setting (element with menu number <X.X.X.0>).
"One level up": A menu element that can be used to jump to a higher
menu level (e.g. <4.1.0.0> to <4.0.0.0>).
Menu error page: In the event of an error, the current error number is
E000
displayed instead of the status page.
• Turn white button: Turn the white button or increase or decrease
settings or menu numbers.
• Press white button: Press the white button to activate a menu ele-
ment or confirm a change.
• Navigate: Perform the steps that follow to navigate in the menu to
the displayed menu number.
• Wait time: The remaining time (in seconds) is displayed on the value
display until the next state is reached automatically or manual input
can be made.
ON • Set DIP switch to the 'OFF' position: Set the DIP switch number "X"
under the housing cover to the 'OFF' position.
X
ON
• Set DIP switch to the 'ON' position: Set the DIP switch number "X"
under the housing cover to the 'ON' position.
X
As soon as the power supply of the electronic module has been estab-
lished, a 2-second display test is carried out, during which all charac-
ters on the display are shown (Fig. 35). Afterwards the status page is
displayed.
After interruption of the power supply, the electronic module carries
out various shut-off functions. The display will be shown for the
duration of this process.
DANGER! Risk of fatal injury!
There can be electrical charges present in the display even if is
switched off.
• Observe general safety instructions!
The standard view on the display is the status page. The current set-
12.3
point is displayed in the number segments. Other settings are dis-
played using symbols.
NOTE:
For dual pump operation, the operating mode is also shown in symbol
format on the status page ("Parallel operation" or "Main/reserve").
The display of the slave pump shows "SL".
Salmson 01/2017