Switching On The Light - Sentiotec PRO-C3 Instructions Pour L'installation Et L'utilisation

Instructions for use for the user
Room temperature control with the additional output
If the mode of the additional output is set to room temperature regulation, a sauna
room temperature can be set, which is regulated using the additional output. This
can be used to regulate the sauna room temperature using only infrared lamps
or infrared heat plates.
Setting options
● Infrared lamps (without foil sensor): 30–70 °C
● Infrared heat plates (with foil sensor): 30–50 °C
If the sauna heater is already active or if it is started additionally, tem-
perature regulation of the additional output is not possible. The mode
is automatically changed to power regulation and the additional output
continues operating at the highest level.

10.6. Switching on the light

When the dimmer switch function is activated
When the dimmer function for the light is activated, the power for the light can
be set to any level between level 0 and 100. At 0, the light is switched off.
100 corresponds to full power.
1. Turn the function selector 2 to position D (light).
► The light symbol lights up.
2. Use the intensity selector 3 to set the preferred light power.
3. Press the intensity selector 3.
► The light switches on.
The intensity selector 3 lights up.
If the light switch 5 is switched on, the sauna room light will operate at
full power. If you wish to dim the light above the intensity selector 3,
switch off the light switch 5.
p. 40/54