Turning On/Off The Control And Cabin Lighting; Quick-Start Steam Operation; Sauna Operation - Sentiotec A3 Instructions D'installation Et D'utilisation

5 Turning on / off the control and the cabin lighting
5.1 Turning on the control
WARNING - Fire hazard:
Prior to turning on the sauna control and when selecting the start-time (time until the stove starts) make sure that no combustible objects have been placed
on top of the stove.
1. Turn on the control with the ON / OFF key 9.
A self-test follows:
• Briefly, the signal lamps 1 / 2 light up.
• A buzzer will beep once.
• The display 3 flashes: 00.00
• The control is ready-to-operate.
5.2 Turning off the control
1. After finishing the sauna / steam bath press the
ON/ OFF key 9.
• The signal lamps 1 / 2 go out.
• The control has been turned off.
5.3 Turning the sauna cabin lighting on / off
1. Key 8 turns sauna interior lighting ON / OFF.
6 Quick-Start
1. Turn on the control according to chapter 5.1.
2. Set the desired temperature using the knob 4.
Note (with a pencil mark) the temperature most agreeable to you.
3. Briefly press time key A (less than 2 seconds)
• The heater starts.
• The signal lamp 2 is lit constantly.
If the cabin temperature measured is less than the desired temperature set, the stove will respond. The stove will heat.
If the cabin temperature measured is greater than the desired temperature set, the stove will not respond.
4. Turn off the control according to chapter 5.2.
WE DO IT FIRST.
Instructions for use for the user
Figure 6

Sauna Operation

P. 11/20
EN