Activating Standby For Remote Operation; Changing The Preset Values - Sentiotec PRO-C3 Instructions Pour L'installation Et L'utilisation

Instructions for use for the user
3. To save the operating time permanently, press the bottom knob for
one second.
► The bottom knob lights up 4 times – the setting is saved.
If you want to set long durations, use the quick preset function:
● Press the intensity selector 3 and turn it at the same time.
► The duration changes in steps of one hour.

10.11. Activating standby for remote operation

EN 60335-2-53 specifies that sauna control units with a remote start function
must be set manually to "Standby for remote operation" mode. This activation
must take place again after each remote start and stop procedure. To do so,
perform the following steps:
1. Turn the function selector 2 to position J (remote start).
► "oFF" appears in the intensity display 4.
2. Press the bottom knob to activate "Standby for remote operation" mode.
► "on" appears in the intensity display 4 and the remote start symbol
starts flashing.
► The sauna control unit is then ready to be started and stopped using a
remote start signal.
► After a remote start and stop, the remote start symbol goes out and the
mode has to be activated again.

10.12. Changing the preset values

You can change the preset values at any time during operation.
1. Turn the function selector 2 to the function you want to change.
2. Use the intensity selector 3 to set the preferred preset value.
p. 44/54