Activating/Deactivating The Foil Sensor - Sentiotec PRO-C3 Instructions Pour L'installation Et L'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 110
Installation instructions, only for experts

Activating/deactivating the foil sensor

If an infrared heat plate is connected to an additional output, the P-ISX-FF foil sen-
sor must be used. The foil sensor must be activated. Perform the following steps:
1. Open the technician menu (see 29).
2. Turn the top knob to the additional output symbol (position C – see point
9.2 on page 34).
► The additional output symbol lights up.
► In the top display, "SEnF" appears.
► In the bottom display, "OFF" appears.
("OFF" means that the foil sensor is deactivated.)
3. Turn the bottom knob to the right.
► In the bottom display, "On" appears.
► The foil sensor is activated.
Changing the light dimming characteristic
Because incandescent bulbs and LEDs react differently to the dimming function, it
is possible to select the dimming characteristic according to the light system used.
1. Open the technician menu (see 29).
2. Turn the top knob to the light symbol (position D – see point 9.2 on page 34).
► The light symbol lights up.
► In the top display, "tYPE" appears.
► In the bottom display, "BULB" appears.
("BULB" means the dimming characteristic for incandescent bulbs is
activated.)
3. Turn the bottom knob to the left.
► In the bottom display, "LED" appears.
("LED" means the dimming characteristic for LEDs is activated.)
p. 32/54

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pro c3

Table des Matières