Starting Combi Mode - Sentiotec PRO-C3 Instructions Pour L'installation Et L'utilisation

Instructions for use for the user

10.4. Starting combi mode

1. Turn the function selector 2 to position A (temperature).
► The temperature symbol lights up.
2. Use the intensity selector 3 to set the preferred temperature.
3. Press the intensity selector 3.
► The sauna heater is switched on and begins to heat up.
► The intensity selector 3 lights up.
► Then the current temperature in the sauna room is displayed in the intensity
display 4. In single-sensor mode, the preset temperature is displayed.
4. Turn the function selector 2 to position B (humidity).
► The humidity symbol lights up.
► The light on the intensity selector 3 goes out.
5. Use the intensity selector 3 to set the preferred humidity.
6. Press the intensity selector 3.
► The evaporator switches on.
► The intensity selector 3 lights up.
► Then the current humidity in the sauna room is displayed in the intensity
display 4. If a humidity temperature sensor is not installed, the preset
humidity is displayed.
If the sauna control unit is used without a humidity temperature sensor
(FTS2), cycle mode is activated. If the sauna room temperature is less
than 30 °C, the evaporator is activated continuously for 10 minutes. This
ensures that the water in the tank reaches a basic temperature level.
Cycle mode then starts.
p. 37/54
EN