Measurement Setup - MIETHKE AAG FV907X Mode D'emploi

Reader Unit Set
The following is displayed on the screen:
Fade-in [Selftest ...]
•
Fade-in [booting ...]
•
The following is displayed on the screen of the
Reader Unit during operation with the plug-in
power unit:
Display for operation with
Reader Unit power supply
NOTE
The control lamp of the plug-in power unit
must be on!
Check the system time, correct if neces-
•
sary, see the [Settings] chapter.
Activate the [On/Off] button.
•
NOTE
The operation of the Reader Unit can be safely
shut down at any time by pressing the [On/
Off] button.
INSTRUCTIONS FOR USE | GB

MEASUREMENT SETUP

The Reader Unit is intended for use by medical
staff at professional healthcare facilities. For
a pressure measurement, the reader must
be placed on a base and the Reader Unit's
antenna is positioned about 10-30 mm away
from the M.scio. The operation of the Reader
Unit to start a measurement is described in the
"Measurement" chapter.
Figure 2: The working distance for telemetric data
transmission, i.e. the distance between the antenna
and the M.scio is 10-30 mm
37