Adjustment Of Precision Angles - Evolution FURY3-S Instructions Originales

www.evolutionpowertools.com

ADJUSTMENT OF pRECiSiON ANGLES

(8.4)
Several checks/adjustments are possible on this machine.
The operator will require a 90°- 45°/45° Set Square
(not supplied) to carry out these checks and adjustments.
wARNiNG: Checks/adjustments must only be conducted with
the machine disconnected from the power supply.
BEVEL ANGLES (0° AND 45°)
0° Bevel Stop Adjustment
• Ensure that the Cutting Head is in the locked down position
with the latching pin fully engaged in its socket.
• Ensure that the Cutting Head is upright, against its stop and
the bevel pointer is indicating 0° on the scale. (Fig. 12)
• Place the Set Square on the table with one short edge
against the table and the other short edge against the blade
(avoiding the TCT tips). (Fig. 13)
• If the blade is blade is not set at exactly 90° (square) to the
rotary table of the machine then adjustment is required.
• Loosen the Bevel Lock Handle and tilt the Cutting Head to
the left.
• Loosen the locknut on the Bevel Angle Adjustment Screw.
(Fig. 14)
• Use a Hex Key to turn the screw in or out to adjust the
inclination of the blade.
• Return the Cutting Head to its upright position and recheck
the angular alignment against the Set Square.
• Repeat the above steps until correct angular alignment
is achieved.
• Tighten the Bevel Angle Adjustment locknut securely.
Fig. 12
Fig. 13
Fig. 14
19
EN