Right & Left Hand Workpiece Supports; Hold Down Clamp - Evolution FURY3-S Instructions Originales

Fig. 4
Fig. 5
Fig. 6
Note: This machine is fitted with a rear stabilizing arm which
is located just below the Bevel Pivot. This arm must be fully
deployed/withdrawn from the base for safety reasons,
particularly if the machine is to be used free standing
on a work bench. (Fig. 4)
This arm will provide extra stability and help prevent the
machine from 'tumbling' in the event of sudden release of the
Cutting Head during free standing cutting operations.
RiGhT & LEFT hAND wORKpiECE SUppORTS
(Fig. 5)
Note: We recommend the workpiece supports are fitted at all
times to increase stability of the saw.
The supplied workpiece supports simply slide into the two (2)
holes found at either side of the machines base.
Approximately 65/70mm of each leg of the workpiece support
should slide into the base. The 'legs' of the workpiece support
must engage with, and slide through the two (2) support
brackets provided in the interior of the base casting.
Secure the Workpiece Support into the base by tightening the
relevant retaining screw.

hOLD DOwN CLAMp

(Fig. 6)
Two sockets (one either side) are incorporated into the rear
of the machines fence. These sockets are for positioning the
Hold Down Clamp.
• Fit the clamp to the retaining socket that best suits the
cutting application, ensuring that it is fully pushed down.
• Tighten the fence thumbscrew to lock the pillar of the clamp
into the fence socket.
• Place the workpiece to be cut onto the saw table, against
the fence and in the desired position.
• Adjust the clamp using the thumbscrews and hand-wheel so
that it securely holds the workpiece to the saw table.
Conduct a 'dry run' with the power disconnected. Ensure that
the Hold Down Clamp does not interfere with the path of the
blade, or with the path of any other part of the Cutting Head as
it is lowered.
14
www.evolutionpowertools.com