Depth Stop; The Sliding Upper Fence Section - Evolution FURY3-S Instructions Originales

a
b
a
Fig. 10
Fig. 11

DEpTh STOp

(Fig. 10)
Use of the depth stop allows the operator to cut slots
in a workpiece.
The downward travel of the Cutting Head can be limited so that
the saw blade does not completely cut through the workpiece.
Note: When using the Depth Stop it is advisable that the
depth of cut is checked using a scrap piece of timber to ensure
that the slot is cut correctly.
By making a cut in the workpiece, and then repeating the cut
but with the workpiece slightly repositioned to the left or
right, it is possible to perform trenching cuts.
To use the depth stop:
• Deploy the depth stop 'stop plate' (a) by pulling it fully to
the right (outwards).
• Loosen the knurled locking nut. (b)
• Adjust the depth stop screw (c) to limit the saw heads travel
to the required depth.
• Once set to the desired depth, tighten the knurled locking
nut (b) against the retaining bracket to lock the depth stop
and ensure that there is no movement.
• When cutting is complete re-adjust the depth stop so that
the Cutting Head can be locked in the down position by the
head latching pin.
Note: In some circumstances the depth stop can be left at
the selected setting. When the depth stop 'stop plate' is
returned to its 'normal' position the depth stop screw will
pass through a machined hole in the 'stop plate' and through
a channel in the machines casting, thus rendering the depth
stop facility inoperative.

ThE SLiDiNG UppER FENCE SECTiON

(7.5)
The Left Hand side of the Fence has an adjustable upper section.
Adjustment may be necessary to provide clearance for the moving
Cutting Head when acute bevel or compound angles are selected.
• Loosen the thumbscrew. (Fig.11)
• Slide the upper section of the Fence leftwards to the
required position and tighten the thumbscrew.
• Conduct a 'dry run' with the power off to confirm that there
is no interference between moving parts as the Cutting
Head is lowered.
18
www.evolutionpowertools.com